4017 aluminum plate sheet

China Supplier：Signi Aluminium

Author ：frank Time:2022-02-17

Guide ：4017 aluminum plate sheet

Ordinary pattern plates are mostly processed with 1060, 3003 and 5052 aluminum alloys in series 1, 3 and 5 as the plate base, and rarely use 4 series aluminum alloys as the plate base. In comparison, series 1 and 3 aluminum alloy checkered plates have low hardness and poor wear resistance. They are mostly used in ordinary environment and rust prevention with less strict application requirements. Although the corrosion resistance of 5-series aluminum alloy checkered plate is good, the anodizing effect is slightly worse than that of 6-series aluminum alloy. 4017 aluminum plate sheet has excellent wear resistance and good anti-skid ability. It is usually used as building materials and decorative parts, such as traffic, building floor, freight car, cold storage, elevator and other anti sliding plates, screen frame and other packaging and decorative materials.

4017 aluminum plate sheet has certain hardness and good wear resistance. After 90 ° bending, it has no naked cracks and orange peel lines. The surface is fine and can be painted. It is suitable for building materials and manufacturing decorative parts, such as traffic, building floor, truck compartment, cold storage, elevator and other anti-skid plates, screen frame and other packaging and decorative materials.

4017 aluminum plate sheet produced by Signi Aluminum Co., Ltd. and its preparation method. The pattern plate is composed of the following weight percentages of raw materials: Si 0.6 ~ 1.6%, Fe ≤ 0.7%, Cu 0.1 ~ 0.5%, Mn 0.6 ~ 1.2%, Mg0 1 ~ 0.5%, Zn ≤ 0.2%, other single impurities < 0.05%, total impurities < 0.15%, and the balance is al. Prepare according to the following steps: batching, smelting and casting; Ingot soaking, machining and milling surface; hot-rolling; Cold rolling bloom; Cold rolling embossing; Continuous annealing; Stretch straightening or cross cutting. 4017 aluminum plate sheet has no naked cracks and orange peel lines after 90 ° bending. The surface is fine and can be painted. It is suitable for building materials and manufacturing decorative parts.